It happened in December... I filled my kiln turned it on the standard program and a few hours latter checked on it only to see an E-0 error on the display. After some research, found it was either a power spike or a complete display failure.
I was pretty depressed and the studio was cold so I put it out of my mind for the holidays and my road trip. Now, I am back to it. Unfortunately, I think I will have to call on some service person; worst case it will cost me $600 plus labor for a new display!!! That is a hard pill to swallow! I am very discouraged...
My goal this month is to find someone to troubleshoot the kiln and get my MIG welder set-up!
