More Issues with the Kiln!

Finally decided to work on my kiln.  Based on the installation  instructions, I called Skutt for some advice .  The touchpad replacement is pretty simple.  However, when I went to remove the wiring harness connections, the wire of one crimped connector came apart.  Apparently it was not crimped correctly at manufacture.  However, I thought oh! perhaps that was the issue with the E0 code!!!  I called Skutt again and technical assured me "probably not, but make sure you fix that crimped wire first before replacing the touchpad!"  So, tomorrow I will try again...I have my fingers crossed.

Road Trip

Yesterday, I went to a the Fine Ats Show in Scottsdale, AZ with Art Escape, a local artwork group to which I am member.  The Phoenix Open (golf) was going on too so we got stuck in some traffic!  However, it was worth it.  The show was great.   I actually bought two small pieces of art from a potter from NC, Vicki Grant.  Below is a shot of some of her larger wall pieces.  They are very organic.

 

I could only afford the two small 6X6 below.  I hope to make a third piece that will not be like them but compliment them.  Then I will install them as a set. 

Not the best pictures.  I will post another picture when I have them hung on the wall...